Beschreibung
- Moisture-hardening single component PU adhesive foam for efficient, clean, cost-saving and long-term secure adhesion of thermal insulation panels in the flat roofing industry
- Ideal for bonding polystyrene (EPS + XPS), rigid PIR/PUR foam boards, rigid PS foam (as rolled or folded insulating sheeting and panels), Polyurethan, rigid phenolic resin foam, compression-resistant mineral wool and bonding onto non-load-bearing aerated concrete blocks
- Suitable for absorbent and non-absorbent substrates, Beton, masonry, Gasbeton, stone, plaster, Holz, thick cold bitumen coatings, sand or slate-covered bituminous sheeting, polystyrene, polyurethane/phenolic resin foam, compression-resistant mineral wool panels, corrosion-protected steel plates, fibre cement boards, chipboard, hard PVC and emulsion paint
- Tested in accordance with the requirements of the ETAG 006 Directive
- Reduced post-expansion
- Not affected by inclination angle
- Mechanical fixing not required
- Suitable for vertical and overhead bonding applications
- For flattening uneven surfaces
- Elastic (does not become brittle)
- Suitable for filling joints
- Cures quickly
- Free of solvents
- Resistant to ageing (not UV-resistant)
- Water-resistant (not waterproof)
- Tested and approved by MPA Bau Hannover (P-NDS04-1015)
Gebrauchsanweisung:
- The instructions provided by the insulation material manufacturer must be observed
- Please read our technical data sheets at en.foerch.com/service/downloads
Grundlage: | Single component polyurethane | |||||||||
Construction materials class | ||||||||||
(GETÖSE 4102 Teil 1): | B 1 (flame-retardant) | |||||||||
Konsistenz: | Firm, does not sag | |||||||||
Berichterstattung: | Ca.. 50 m | |||||||||
Ca.. 17 m² (3 strands / metre) | ||||||||||
Bearbeitungsdauer: | Ca.. 6 Min. (30 mm strand of | |||||||||
Klebstoff) | ||||||||||
Curing time: | Ca.. 60 Protokoll | |||||||||
(30 mm adhesive strip) | ||||||||||
Capable of load bearing: | after approx. 12 Stunden |
68008110
K02_150_1